CushionGuide

A Reading by HanaDaybed Cushions & Covers

A rust suede-look daybed cushion, tested against ordinary life

Walnut, brass, one throw, no pillows. A spare room shows every mark. Here is what children, paws, coffee and afternoon sun will do to it.

The quick answer

A suede-look faux leather daybed cushion handles daily life well if you blot spills at once, keep it out of long direct sun, and accept that a brushed face shows every stroke as a change of shade. Claws mark every fabric. For sleeping or small children, a washable soft performance weave is the easier choice.

Rust orange suede-finish daybed cushion and round bolster on a walnut platform with brass legs, cream knit throw, jute rugSave
Burnt-orange faux suede on walnut and brass, left bare except for one cream throw so the color carries the room.
Ivory faux leather daybed cushion with matching bolster, sage and taupe pillows, on a walnut plinth beside a fiddle leaf figSave
An all-cream seat and bolster on a deep walnut base, with a sage pillow as the only hint of color.
Denim blue daybed cushion and bolster on a walnut storage base with oatmeal lumbar, fringed throw and olive treeSave
The same blue fabric looks richer on dark walnut, with a lumbar pillow and an olive tree adding texture.
Chocolate brown linen-look daybed cushion with sand piping and bolster, oatmeal knit throw and dried wheat in stonewareSave
Light sand piping draws a fine line around a dark seat, matching the oak and the knit throw.
Mauve textured box cushion with self piping on a carved cream French daybed with knit throw and linen pillowSave
A mauve box cushion made to fit a carved cream French daybed, softened with a knit throw and a linen pillow.
Mushroom taupe suede-finish daybed cushion and bolster on a pale oak drawer base, kilim and knit pillows, olive treeSave
A brushed faux-suede seat on a pale oak storage base, dressed Mediterranean-style with kilim pillows, a caramel throw and an olive tree.
Close-up of an ecru linen-look daybed cushion and bolster with taupe piping, stoneware mug and open magazineSave
Up close, the taupe welt shows how neatly the bolster's round end and the seat's box edge are finished.

Pinned by Hana: five notes in evening light

Five pins, from the piped end of the bolster to the brass on the nesting tables.

Pinned: Rust orange suede-finish daybed cushion and round bolster on a walnut platform with brass legs, cream knit throw, jute rug
  1. Rust bolster

    The brushed surface shifts shade as it curves, which makes a round bolster look almost velvety.

  2. Piped end cap

    A self welt around the circle keeps the bolster end flat and crisp.

  3. Bare seat top

    No pillows at all: color and brushed texture are decoration enough.

  4. Cream knit throw

    One pale throw at the far end lightens the corner without hiding the fabric.

  5. Nesting tables

    Brass-trimmed walnut tables repeat the platform legs for a matched mid-century set.

  1. Rust bolsterThe brushed surface shifts shade as it curves, which makes a round bolster look almost velvety.
  2. Piped end capA self welt around the circle keeps the bolster end flat and crisp.
  3. Bare seat topNo pillows at all: color and brushed texture are decoration enough.
  4. Cream knit throwOne pale throw at the far end lightens the corner without hiding the fabric.
  5. Nesting tablesBrass-trimmed walnut tables repeat the platform legs for a matched mid-century set.

Read the daybed before you test it

A walnut platform on brass legs. A rust cushion across it, box-edged, with a self welt. A round bolster along the wall. One cream knit throw at the far end. Nothing else.

The seat is thick enough to hide the slats and thin enough to keep the platform's floating line. That is the proportion to copy. Height is a feeling, and here it says low and unhurried.

The fabric is a suede-look faux leather in rust and burnt orange. On the flat seat it reads matte. On the curve of the bolster the brushed surface turns lighter and darker as it rolls, almost like velvet. A self welt around each end cap keeps the circle flat.

The walls are warm clay plaster. The floor is dark herringbone under a jute rug. Walnut and brass nesting tables repeat the legs. In dim evening light the cushion is the brightest thing in the room. That is the point.

No throw pillows. The color is the decoration.

What would you take away from your own daybed? See more daybed cushions, the faux leather swatch library and living room cushions.

Five tests, one brushed cushion

TestWhat happensWhat to do
ChildrenSticky hands and shoes mark a brushed faceBlot, then brush the nap one way; a washable soft weave suits a playroom better
PetsClaws mark every fabric; a paw leaves a trail of changed shadeLay the throw where the animal settles; brush the nap back
SpillsRubbing spreads a stain and flattens the napBlot at once with a dry cloth, then a barely damp one
SunIndoor fabrics have limited UV resistance and can fade in long, strong sunTurn the cushion end to end each season; draw a sheer on summer afternoons
GuestsThe daybed becomes a bedOn daybed sets only the seat cover comes off for washing; filled bolsters are spot-cleaned
A real project

Two mattresses, one cover, 11 3/4 inches

A buyer wrote with a daybed mattress of 31 1/2 x 78 3/4 x 8 1/4 in (80 x 200 x 21 cm). The plan had changed. Two mattresses, each 5 7/8 in (15 cm), would now be stacked under one cover.

The workshop offered two heights. 8 1/4 in (21 cm), the old number. Or 11 3/4 in (30 cm), the new stack. The buyer chose 11 3/4 in, so both layers sit inside one zippered cover.

A cover is measured on what it will hold. Not on what it held before. The tape goes on the stack.

Sizes
31 1/2 x 78 3/4 x 11 3/4 in (80 x 200 x 30 cm)
Fabric
Not specified

The lesson: For stacked mattresses, measure the combined height and order the cover to that total.

Buyer questions: parts of a set, fabric limits, a thick twin

  1. A common question

    Can I buy just the mattress cover and the back pillows from a Hemnes daybed set?

    The workshop's answer

    Yes. Two filled backrests and a mattress cover without foam can be ordered on their own. The standard backrests are L-shaped to wrap the sides; a straight, back-only pillow of about 36 x 12 in is made through a custom listing.

  2. A common question

    Is there any fabric I can't use for a bench cushion or a daybed mattress cover?

    The workshop's answer

    No. Velvet, the soft performance weave, linen and linen-look, and the outdoor range all work for bench cushions and daybed covers, and families can be mixed, such as a linen body with velvet piping. Velvet is indoor-only and not water-resistant, so choose the outdoor range for anything that may get damp.

  3. A common question

    Will your daybed slipcover fit a twin mattress that is 12.5 inches thick?

    The workshop's answer

    Yes. The zippered corduroy daybed cover is made to your mattress, so write the sizes in the order; a standard twin is 39 x 75 x 12.5 in. For one buyer, order to door ran 9 to 11 business days to the US.

On the cutting table: the rust daybed

PieceDaybed seat cushion with a round bolster
FabricRust suede-look faux leather, brushed face
PipingSelf welt on the seat and around each bolster end
EdgeBox edge
BolsterAbout 8 in (20 cm) across as standard, 10 in (25 cm) possible; arrives filled
CoverZippered seat cover; zipper on the back edge or the underside
CareBlot and wipe; filled bolsters are spot-cleaned, not washed
Best forLiving-room daybeds in soft, indirect light

Order this cushion

Have it made

Have this made — ask Hana’s workshop

Measure once, slowly. Write the numbers here. The workshop will go over them with you. — Hana

Leave your details and the workshop will call you to confirm measurements, fabric, foam and piping. No prices, dates or payment on this page: it is a request, not an order.

Fabric · Foam · Pipingwhat the workshop will confirm with you

Fabric
Rust suede-look faux leather, brushed face
Foam
The core: its density and thickness set the feel.
Piping
Self welt on the seat and around each bolster end
Only for this request: no marketing calls or texts. Outside the US, add the country code.
In inches: length × depth × thickness, plus any angles or cut corners.

* Required. A member of the workshop team will call you to talk it through; nothing is charged and nothing is made until you have agreed on every detail with them.

We use these details only to answer this request and make your cushion: your name and contact details, the cushion details and photos you send, the page you came from and the ad or link that brought you, if any. The workshop that makes the cushions receives them. We don't sell them or share them for advertising, and we delete requests after 24 months. Privacy notice for requests.

Nothing is made or charged until you approve the details.

Want to pick the shape and add photos? Use the full quote form

A daybed cover for two stacked 5 7/8 in mattresses is ordered at 11 3/4 in, the full stack, not the height of the mattress it replaced.

Hana

Questions buyers ask next

Is faux suede a sensible choice for a daybed used every day?

Yes, with habits: blot spills at once, brush the nap one way, and keep it out of long direct sun. If the daybed is a child's bed or a guest bed most nights, a washable soft performance weave is easier to live with.

Why does the bolster look darker on one side?

A brushed surface reflects light by the direction of its fibers. On a round bolster that direction changes all the way around, so one side looks lighter and one darker. It is the same effect that makes velvet shade, and it is not a flaw.

How big should an armrest bolster be on a daybed?

The standard round bolster is about 8 in (20 cm) across, with 10 in (25 cm) possible, and any size can be made. For an armrest, the length matches the seat depth or runs about 4 in (10 cm) shorter.

Can a dog or cat share a faux leather daybed?

They can, but claws mark every fabric, and a brushed face shows each paw as a change of shade. Lay a throw where the animal settles, and look at the pet-friendly weaves if claws are a daily event.

— Hana